
Fuel Oil Burner Service Plans
Plan 1 Annual Cleaning and Service
$139.00 + parts
This our basic 15 point service plan, it includes a thorough annual tune-up of your burner and cleaning of your furnace or boiler. Plan 1 covers the following services, which we will perform as needed at the time of tune-up. Parts are an additional cost.
-
Inspect oil tank, lines and fittings
-
Change,clean, or inspect filters and strainers
-
Clean and adjust nozzle assembly
-
Replace nozzle
-
Check and set ignition assembly
-
Check primary safety control operation
-
Oil motors
-
Vacuum clean heat exchanger
-
Vacuum clean smoke pipe and chimney base
-
Check operating controls
-
Seal air leaks at chimney base and smoke pipe
-
Adjust oil burner efficiency and combustion with testing equipment
-
Operate through a heating cycle
-
Check, clean, or replace air filters
-
Make necessary suggestions or recommendations
Our Heating and Air Conditioning Services include:
- Air Conditioning Installation & Service
- Emergency Service 24 Hours Per Day
- Heating Oil
- Heating Installations
- Heating Oil Budget Plans
- Heating Oil Pre-purchase plans
- Service Contracts

Plan 2 Annual Cleaning and Service
$208.95
Plan 2 includes all of plan 1 plus provides one year coverage/replacement on most parts, labor to replace them, and calls associated with your oil burner. Extra zones can be covered for $8.00 each. See below for a list of covered parts. To qualify for Plan 2 all heating oil needs to be purchased on an automatic delivery basis by Walker Fuels. For a full list of non-covered parts and terms please contact our office.
-
Air filters, 1 set w/service
-
Aquastat
-
Blower bearings
-
Blower belt
-
Blower motor 1/3 hp max
-
Burner coupling
-
Burner fan
-
Burner motor
-
Buss Bars
-
Cad cell eye
-
Cad cell relay
-
Circulator bearing assembly (1) living room
-
Circulator coupling (1) living room
-
Circulator direct drive (1) living room
-
Circulator motor (1) living room
-
Circulator relay (1) living room
-
Delayed oil valve
-
Draft regulator
-
Electrodes
-
End cone (combustion cone)
-
Fan/limit combination
-
Fan pulley
-
Fan switch
-
Fuel filter complete
-
Fuel pump seal
-
Ignition transformer
-
Ignitors and cables
-
Limit switch
-
Low voltage transformer
-
Low voltage wiring
-
Motor capacitor
-
Motor pulley
-
Nozzle adaptor
-
Nozzle line
-
Oil burner switch
-
Oil fuel pump
-
Porcelains
-
Pressure guage
-
Pressuretrol
-
Solenoid oil valve
-
Stack relay
-
Temperature guage
-
Thermostat (standard heating only)(1)
-
Triple aquastat